[Linux-Biella] ubuntu 8.10 wireless

Ax andre.noris a tiscali.it
Sab 14 Feb 2009 15:25:48 CET


Daniele Vallini ha scritto:
> Il Sat, 14 Feb 2009 10:49:09 +0100
> Ax <andre.noris a tiscali.it> ha scritto:
>
>   
>>> Quelle righe bisognerebbe leggerle !
>>>       
>
> Non lo dico piu', forse e' piu' breve la Divina Commedia :-)
>   

e quella era la versione corta ;-P
> Proporrei, per avere collaborazione in rete, di postare l'output
> dei seguenti comandi:
>
> ifconfig
>   


eth0      Link encap:Ethernet  HWaddr 00:1a:4b:70:ca:cf 
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisioni:0 txqueuelen:1000
          Byte RX:0 (0.0 B)  Byte TX:0 (0.0 B)
          Interrupt:18

lo        Link encap:Loopback locale 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:232619 errors:0 dropped:0 overruns:0 frame:0
          TX packets:232619 errors:0 dropped:0 overruns:0 carrier:0
          collisioni:0 txqueuelen:0
          Byte RX:188129524 (188.1 MB)  Byte TX:188129524 (188.1 MB)

vmnet1    Link encap:Ethernet  HWaddr 00:50:56:c0:00:01 
          inet addr:192.168.123.1  Bcast:192.168.123.255  Mask:255.255.255.0
          inet6 addr: fe80::250:56ff:fec0:1/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:316 errors:0 dropped:0 overruns:0 frame:0
          TX packets:290 errors:0 dropped:0 overruns:0 carrier:0
          collisioni:0 txqueuelen:1000
          Byte RX:0 (0.0 B)  Byte TX:0 (0.0 B)

wlan0     Link encap:Ethernet  HWaddr 00:1c:bf:0c:23:2d
          inet addr:192.168.10.11  Bcast:192.168.10.255  Mask:255.255.255.0
          inet6 addr: fe80::21c:bfff:fe0c:294e/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:547314 errors:0 dropped:0 overruns:0 frame:0
          TX packets:992507 errors:0 dropped:0 overruns:0 carrier:0
          collisioni:0 txqueuelen:1000
          Byte RX:89492782 (89.4 MB)  Byte TX:1387938297 (1.3 GB)

wmaster0  Link encap:UNSPEC  HWaddr 
00-1C-BF-0C-29-4E-39-34-00-00-00-00-00-00-00-00 
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisioni:0 txqueuelen:1000
          Byte RX:0 (0.0 B)  Byte TX:0 (0.0 B)


> iwconfig
>   
lo        no wireless extensions.

eth0      no wireless extensions.

wmaster0  no wireless extensions.

wlan0     IEEE 802.11abg  ESSID:"acs" 
          Mode:Managed  Frequency:2.462 GHz  Access Point: 
00:C0:49:DA:A2:D8  
          Bit Rate=54 Mb/s   Tx-Power=15 dBm  
          Retry min limit:7   RTS thr:off   Fragment thr=2352 B  
          Encryption 
key:A150-9944-5883-9B9C-FF78-7DA1-DDDD-C448-7310-545D-55B4-E0BE-2E51-590A-D12D-1A43 
[3]   Security mode:open
          Power Management:off
          Link Quality=90/100  Signal level:-41 dBm  Noise level=-83 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

pan0      no wireless extensions.

vmnet1    no wireless extensions.

> route
>   

Tabella di routing IP del kernel
Destination     Gateway         Genmask         Flags Metric Ref    Use 
Iface
192.168.10.0    0.0.0.0         255.255.255.0   U     2      0        0 
wlan0
192.168.123.0   0.0.0.0         255.255.255.0   U     0      0        0 
vmnet1
0.0.0.0         192.168.10.1    0.0.0.0         UG    0      0        0 
wlan0

> cat /etc/network/interfaces
>
>   
auto lo
iface lo inet loopback

> Almeno la rete vediamo esattamente come e' configurata.
>   
ma secondo me non se ne cava nulla cosė!
il comportamento ricorda anomalie nel driver tanto che cercando un po' 
in rete ho trovato gente che invece di usare iwl3945 usa ipw3945 cosa 
che non fa al caso mio in quanto non posso ricompilare il driver tutte 
le volte che aggiorno il kernel.



Maggiori informazioni sulla lista Linux